Getting to COM1, NUS-SOC, and my Office (LeongHW)

My Office and How to get there (LeongHW)

My office (since July 2007) is in Block COM1 (the old NUS Law Building), and the address is

You can find it on Google Map at: | Google-Map

Alternatively, you can use the NUS campus map at http://www.nus.edu.sg/campusmap/.


Driving Directions (for visitors to NUS)

[Note: If you have NUS-staff season parking or NUS Visitor Parking Coupon, park at CarPark-13 (next to COM1),
else park in CarPark-15 (near Temasek Hall about 200m away, off Kent Ridge Drive).]

  1. From Clementi Road drive South (past the AYE flyover)
        until about 1km past AYE (after School of Design and Environment on your left)

  2. Turn left into "Kent Ridge Crescent, (2nd entrance into NUS),
        Go about 140m, keep to the right

  3. Turn right into "Kent Ridge Drive".
    Go about 400m, and then
        see (4) to get to COM1 Car Porch,
        see (5) to park in CarPark 13
        see (6) to park in Visitor CarPark 15 (Temasek Hall)

  4. To get to Block COM1 Car Porch: (for taxi or to drop off people)

  5. To park in CarPark 13 (Staff Parking) [with Visitor Pass]:

  6. To park in Visitor CarPark 15:


FRIENDLY WARNING:


Coming to COM1 by bus/MRT

  • Via NUS internal bus:
    If you are on campus, take free NUS internal bus B, D1, A1 (or A2, they go in opposite directions).
    Alight at the "COM2" bus-stop; you are right now next to COM1.

  • By public transport:

    From "Central Library", COM1 is just a short walking distance away.
    Walk under the the Central Forum, into grass area;
    Follow the pathway (turning right a bit) behind LT15, LT16.
    Then walk into Block COM1 (from the side entrance).
    Take stair-case to second floor; Enter COM1 from there;
    (Note: Ask students for directions, if necessary.)


  • Alternatively, you can see the official School of Computing's "Getting to NUS SOC" guide.


    by Leong Hon Wai, Computer Science, NUS. (Started: Dec-2007, Last revised Jun-2018)
    [Prints well with A4-page-offsets l=r=b=t=0.5"=12.7mm]